A strip of SPC flooring right behind a shop window can spend hours in the sun while the rest of the floor stays in shade. If you plan to run one floor across both areas, check what the exact plank is approved for before you sign off the collection.

You can specify some SPC floors for spaces with large windows under the conditions in their installation instructions. Start with the amount of direct sun, whether the space is climate controlled during and outside opening hours, and how far the floor runs from the glass into the room. Ask the supplier to confirm those conditions in writing for the product you plan to order.

Check heat and colour separately

Heat can change how the floor moves. Sunlight can warm a small section near the glass. A floating floor needs the clearances specified for that installation, including around columns, door frames and fixed shop fittings. Mark those points on the floor plan so the installer can see where the floor needs space to move.

Light exposure can change how the floor looks. Long exposure can affect the colour of the surface. Ask for the colourfastness evidence for the finish you are approving and check what the warranty says about fading or sun damage. The MMFA installation bulletin, December 2023, sections 6.1–6.3 discusses dimensional changes from temperature and prolonged light exposure separately for floating multilayer floors.

Read each temperature limit in context

Karndean’s July 2023 installation guide for its i4F drop-lock rigid-core products gives a useful example. The sunroom section calls out local heating through large windows or glass doors and the importance of expansion gaps. In a separate underfloor-heating section, the same guide specifies a maximum of 27°C at the interface between the backing and the subfloor. That figure applies to underfloor heating for the products covered by the guide. For your sunlit area, ask which limits and protective measures apply to that exposure and where any stated temperature is measured.

Put the window zone on your approval sheet

What to record What to confirm before you approve
The room Mark the glazing and the area that gets direct sun. Record any planned shading and periods when the space is unconditioned.
The exact flooring Match the SKU, plank format and construction to the current installation instructions for your market. Ask for written confirmation of suitability for the proposed exposure.
The layout Check the permitted continuous run and required expansion clearances or breaks for those conditions. Put them on the drawing before the floor layout is agreed.
The surface and warranty Keep the finish’s colourfastness evidence and check how the warranty treats fading and heat damage for this application. Record any conditions you need to pass on to your customer.

If the same floor will be sold for both standard interiors and heavily glazed spaces, keep the permitted applications with the product specification and the instructions that ship with it. For your next SPC collection, send us the proposed board, a floor plan and the glazing conditions so we can check what the factory can document for that use.

Euro Vietnam · InsightsExplore more insights