---
title: "SPC Flooring Gloss Control — How to Match Your Approved Matt Finish"
url: "https://euro-vietnam.com/journal/spc-flooring-gloss-control/"
---

# SPC Flooring Gloss Control — How to Match Your Approved Matt Finish

Set up a practical gloss check for your SPC flooring, from the reference plank you approve to the cartons you inspect before shipment.

Lay planks from two cartons of your oak-look SPC flooring side by side. The colour matches, but one set of boards catches the light as you walk past. Your inspector needs a repeatable way to tell whether that change is within the finish you approved. Set up the comparison while your reference plank and pilot boards are still on the table.

## Keep a finished plank from your approval

Sign off on a finished plank with the decor, embossing and coating you intend to run. Record its sample ID, SKU, finish code and revision on the approval sheet. Keep the reference clean and protected. If the factory and inspection team need separate reference boards, compare and approve both together.

Agree which changes call for a new first-off sample, such as changing the embossing texture, switching the coating or moving to a different curing process. An Excimer-cured coating is one example of how a change at the surface can alter reflected light. Keep the approved finish tied to the board you sign off. [Hesse Lignal technical guide](https://www.hesse-lignal.com/en_EN/inspiration/technologien/excimer-technology/) (undated).

## Give your inspector a repeatable gloss check

1. **Fix the viewing conditions.** Place the production plank beside the reference with the grain running the same way. Compare both in diffuse light and under a fixed light from the side. Keep the light, viewing position and board orientation consistent across inspections.
2. **Agree how to measure your surface.** If gloss readings are repeatable on the finished texture, specify the instrument, measurement angle, direction and positions on the plank. Include how the instrument is checked and define the acceptance range with the pilot boards. ISO 2813:2014 describes three measurement geometries for smooth, flat, opaque coated surfaces. For textured planks, check that your agreed method gives consistent readings on that specific finish. [ISO 2813:2014](https://www.iso.org/standard/56807.html), [BYK Instruments guide to reliable gloss data](https://media.byk-instruments.com/shop/Misc/Whitepaper/White_Paper_Guide_for_Reliable_Gloss_Data_EN_20230605.pdf).
3. **Record results by lot and carton.** Agree where to sample across the run. Keep the individual results and their carton IDs so a few boards with a visible sheen difference can be traced even when the overall average looks acceptable.

## Agree what happens when a lot looks different

If a group of planks looks brighter, repeat the check with clean boards and the approved reference under the same setup. If the difference still falls outside your agreed criteria, hold the affected lot for review. Retain a sample and the inspection record so you can check whether the difference is isolated or runs through the lot. Agree on the disposition before release and confirm any revised finish on a new board before the next run.

Bring your reference plank, the intended finish and any existing inspection sheet when you discuss the specification. Use the same approval record to carry the look from the sample through production. [SPC flooring product development](https://euro-vietnam.com/spc-flooring/), [From a reference board to a colour-matched sample](https://euro-vietnam.com/journal/from-a-reference-board-to-a-colour-matched-flooring-sample-in-vietnam/).

## Your next step

Setting the finish requirements for your next SPC flooring collection?

[Discuss your SPC finish specification](https://euro-vietnam.com/#inquiry)
